Y-cam Camera Bedienungsanleitung PDF herunterladen (Seite 16)

Page 16

3.0 INSTALLATION

For initial setup, you need to connect the Y-cam directly to your router or switch with a network cable. You cannot

connect wirelessly to the camera without first setting it up via a network cable.

You should connect the Y-cam directly in to your internet router (normally supplied by your broadband provider) or a

network switch or hub (that is connected to your computers network).

Using the standard Ethernet network cable, plug this in to the network connection socket on the Y-cam at one end, and

plug the other end in to a spare port on your router/switch.

Using the Power Adaptor (supplied), plug one end in to the Power Connection socket on the Y-cam. Plug the other end

in to an electrical socket and turn the power on.

The Connectivity Status LEDs will light up*. Your router/switch will then begin to communicate with the camera.

You can now proceed to the Software Installation section.

* - The Y-cam Bullets Status LED is located inside the camera behind the lens and infrared LEDs

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Keine Kommentare

Y-cam Camera Bedienungsanleitung Seite 16